| Phenomenon |
Reasons |
Maintenance |
| Without steam |
1. steam generator without water.
2. inside infrared pipe burn out of steam generator.
3. block of steam spray mouth.
4. probe out off control.
5. the temperature inside steam room is over the
temperature what were set.
6. after fill into water it is still not the time for
steam working.
7. it is overtime for the setting time.
8. unconnect with the control wire. |
1. check if the switch of water in be turn on or not.
2. change the infrared pipe.
3. get rid of mess.
4. check the connection wire and change the probe.
5. waiting decrease the temperature.
6. be waiting few minutes.
7. adjust the setting time.
8. connect to control wire. |
| Without O3 |
1. system be damaged |
1. change the system |
Water pump
unworking
|
1. water pump without power.
2. air pipe which connect with switch of air valve
be insected untightly.
3. switch of air valve out of control.
4. air pipe leaking.
5. rotor of water pump unworking.
6. water pump be burned. |
1. check if the power of water pump get through.
2. to insect the air pipe tightly.
3. change the switch of air valve.
4. change the air pipes.
5. check if there are stems in the water pump,take apart
those air pipes in order to get rid of stems.
6. change the water pump. |
Volume under
control
|
1. suction of water pump is not enough.
2. air adjustment valve working abnormal.
3. block of jets. |
1. check the water pump if it is working normally.
2. change the air valve.
3. get rid of mess. |
| Water pipe leaking |
1. plastic seal ring be connected untightly.
2. screws unlock.
3.connection is glued not good.
4. water pipe be damaged. |
1. change the plastic seal ring.
2. screws should be installed tightly.
3. get rid of the PVC glue then stick. the glue again
till it is be well done.
4. change the water pipe. |
Computer panel
under control |
1. power not be connected well,electronic leakage
device without power.
2. switch of control panel out of control. |
1. get through the power again.
2. change the computer panel. |
| Without lighting |
1. bulb be burned.
2. without power.
3. switch of control panel out of control. |
1. change bulb.
2. get through power gain.
3. maintain or change the computer panel. |
Telephone
connection
unworking |
1. telephone wire not connected well or be
damaged.
2. telephone's device be blocked. |
1. check the wires of telephone and electronic box
if get through or not, if there is something wrong replace.
by the similar wires.
2. get rid of mess. |
| Without sounds |
1. speaker be broken
2. without power
3. switch of control panel out of control. |
1. change the speaker
2. get through power again.
3. maintain or change the computer panel. |
Henry163